Tamper Indicator & Trigger Zone Id; Appendix 1 - Understanding The Siren Chirps; Light Flashes - ENFORCER 100LB Owner's Manual

Appendix 1 — UNDERSTANDING THE SIREN
CHIRPS AND LIGHT FLASHES
A. 1 chirp/flash:
When the
alarm is armed.
When a door is closed, the alarm will
arm in 30 seconds (passive arming).
30 seconds after the ignition switch is
turned OFF and all doors are closed
(or delayed domelights turn OFF), the
alarm is armed (passive arming).
Successfully entered the valet mode.
B. 2 chirps/flashes:
When the
alarm is disarmed.
Successfully exited the valet mode.
C. 3 chirps/flashes:
When pressing the
alarm, indicates the alarm arms even
though it is not set properly (door not
closed, or broken switch, or domelight
is still ON.
NOTE: If the delayed domelights are
ON when the
siren will chirp 3 times. This gives the
impression that the door is open when
it may really be closed.
When pressing the
by the button, indicates sensor is
bypassed.
Completed emergency disarm.
Pre-intrusion warns potential thieves or
vandals who trigger the first stage of
any dual-stage sensor that is
connected to the alarm.
ENFORCER 100LB/100CB Owner's Manual
button is pressed, the
button is pressed, the
button to arm the
button is pressed, the
button followed
D. 4 flashes only:
When the
during the valet mode.
E. 2 Chirps/ 7 flashes:
When pressing the
disarm the alarm, indicates the alarm
was triggered.
NOTE — The chirps for arm, disarm, zone
bypass, sensor bypass, emergency disarm,
valet, and tamper can be deleted. (Ask your
dealer.)
or button is pressed
button to
Page 11