Table of Contents
Advertisement
INSTALL USING LAP-SHOULDER BELT
While still pulling the shoulder belt tight, close the Lock-Off Door (a)
7
and push down on the lever to lock the Lock-Off and belt (b).
Keep Lock-Off closed at all times.
Do NOT pull on shoulder belt after the Lock-Off is closed.
This could damage the Lock-Off and/or the vehicle belt.
CHECK YOUR WORK
Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Vehicle belt should remain tight and Child Restraint should
not move more than 1" (25 mm) from vehicle seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING use. Make sure infant's head
does not fall forward. If necessary, loosen the vehicle belt, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
50
INSTALL USING LAP-SHOULDER BELT
7a
7b
51
Hide quick links:
Advertisement
Table of Contents
