Table of Contents
Advertisement
Useful adjustment settings
For adjusting a picture's horizontal and vertical
position,
Press MENU and the MENU screen displays,
Press
./T
I
~/~
to move an image on the screen to
the desired position. Press ENTER to return to the initial
image position.
Press
~/~
to select "Setup",
Press
./T
to select "Position", and then
press ENTER,
Press
./T
to select "H-Pos." or "V-Pas,",
• While pressing
./~
/ ....
/~
/ an on-screen image,
"Adjusting Position" displays to the desired position,
• This setting cannot be stored, Once the TV shuts down or
enters standby mode, the setting is erased. To move the
picture around the screen again, you must perform the
above procedure again.
• The image position setting using the steps on this page
can be stored, Select either according to your objectives,
• "TV", "INPUT1", "INPUT2", "INPUT3" and "INPUT4" can
each adjust the image position setting on this page. The
same for view modes,
• An on-screen image from PC cannot be moved around.
• Even when the image fills the screen, its position can be
adjusted with this function.
• Press ENTER to reset the image to original positions,
•
t
•
Centers the image by moving it up or
down.
Centers the image by moving it to the left
or right.
Press
~/~
to adjust the item to your desired
position,
V-Pos.
H-Pos.
I~'
.'\~'*'
• For resetting all adjustment items to the factory preset
values, press
.ry
to select "Reset", and then press
ENTER,
• Adjustments are stored separately according to input
source.
• You can easily move the image position as shown on this
page, but when the power is switched off the image will
return to the previously memorized position,
@-58
Advertisement
Table of Contents
