Table of Contents
Advertisement
Basic adjustment settings
Power control setting allows you to save energy,
No signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down,
Repeat steps 1 and 2 in No signal off.
Press MENU and the MENU screen displays.
Press
./T
to select
II
Power Management",
and then press ENTER,
• If no signal inputs for 8 seconds, the TV
enters standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on,
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off,
• The TV turns on again by pressing
TV
POWER on the remote control unit. (See
page 17),
• Pressing POWER on the TV will have the
same result.
• No power management
• Factory preset value.
Press
./T
to select "Mode1" or "Mode2",
and then press ENTER.
Mode2
Mode1
Off
• Five minutes before the power shuts down,
remaining time displays every minute.
Press
~/~
to select liEnable", and then
press ENTER.
Press
./T
to select "No Signal Off", and
then press ENTER.
Press
~/~
to select "Power Control",
• "Disable" is factory preset value.
• When a TV program finishes, this function may not operate.
No operation off
When set to liEnable", the power will automatically shut
down if there is no operation for 3 hours,
Repeat steps 1 and 2 in No signal off,
Press
./T
to select "No Operation Off", and
then press ENTER,
Press
~/~
to select liEnable", and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
l&lI!
• When using a digital PC and setting "Mode2" in Power
management, the power may not turn back on
automatically even if the signal inputs again,
• If you turn off the power by disconnecting AC cord when
setting "Mode2" in power management, the TV may not
function properly after turning the power on again, In such
case, press TV POWER on the remote control unit.
• Pressing POWER on the TV will have the same result.
• "Disable" is factory preset value,
(Q§)
-44
Advertisement
Table of Contents
