Troubleshooting; Power Indicator Is Not Illuminated; No Sound; Cannot Tune To Dab/Dab+ Preset Station - Rotel RT-11 Owner's Manual

Dab/fm stereo tuner
Hide thumbs Also See for RT-11:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
English
NOTE: The input buttons i-Radio, Network, and AUX not labeled in
the illustration figure 2, do not operate with the RT-11.

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections, or
improper control settings. If you encounter problems, isolate the area of the
difficulty, check the control settings, determine the cause of the fault and
make the necessary changes. If you are unable to get sound, refer to the
suggestions for the following conditions:

Power Indicator Is Not Illuminated

The power Indicator should be illuminated whenever the unit is plugged into
the wall power outlet and is pushed in. If it does not light, test the power
outlet with another electrical device, such as a lamp. Be sure the power
outlet being used is not controlled by a switch that has been turned off.

No Sound

Check the cables between the output and the pre-amplifier inputs, be sure
they are connected properly. Refer to Fig. 3.

Cannot Tune to DAB/DAB+ Preset Station

Some stations may become unavailable and will be displayed in the Station
List with a "?" character in front of the station name. These stations are no
longer broadcasting or received by the RT-11. Presets that are set to these
stations will not function and if selected the RT-11 will display the DAB
menu. To remove stations no longer transmitting use the PRUNE function
in the DAB Menu. This will remove these stations from the Station List and
from the Preset list.

Specifications

FM Tuner
Usable Sensitivity
50dB Quieting Sensitivity
Signal to Noise Ratio (at 65 dBf)
MONO
STEREO
Harmonic Distortion (at 65 dBf)
MONO
STEREO
Frequency Response
Stereo Separation
(100Hz/1kHz)
Output level
Antenna Input
DAB Tuner
Sensitivity
Tuning Range
Audio Data Rate
Frequency Response
Analog Output
Antenna Input
General
Power Consumption
Standby Power Consumption
BTU (at 5 watts)
Power Requirements (AC)
USA:
Europe:
Dimensions (W x H x D)
Front panel height
Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice
Rotel and the Rotel Hifi logo are registered trademarks of The Rotel Co.,
Ltd. Tokyo, Japan.
11
22.2 dBf
27.2 dBf (mono)
63 dBf
60 dBf
0.2%
0.3%
10Hz - 15kHz, ± 3dB
40dB/ 37dB
1.0 V
75 ohms F connector
- 80 dBm
Band III (174 - 240MHz)
224kbps (Max)
20 - 20k Hz +/- 1.0 dB
2.1V at 0 dBFS
75 ohms F connector
10 watts
0.5 watts
17 BTU/h
120V, 60Hz
230V, 50Hz
430 x 73 x 330 mm
(17 x 2
/
x 13 in)
7
8
60 mm
4.3 kg (9.48 lbs)

Advertisement

Chapters

Table of Contents
loading

Table of Contents