Assembly And Adjustments; Operation - DeWalt DCT410 Original Instructions Manual

Eng lis h
When using a cable reel, always unwind the cable
completely.

assemBly and adjUstments

WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always turn the inspection camera
off before inserting or removing the
battery pack.
WARNING: Use only D
packs and chargers.
screen (fig. 4)
When the screen is attached to the handle set with
a battery, it will receive a charge from the battery.
Ensure the screen is fully charged before use.
When the screen is disengaged from the handle set,
a battery icon appears in the upper left corner. This
icon also displays the current charge of the screen.
To install the screen (e) into the handle set (g), align
the screen with the rails on the handle set and slide
it firmly into the handle until you hear the lock snap
into place.
To remove the screen from the handle set, firmly
slide the screen up from the tool handle.
The screen can be turned on and viewed when it
is not attached to the handle set, allowing easier
maneuverability of the camera.
Camera Cable (fig. 5)
Align the camera cable (c) with the camera
connector (d). Push in and turn the connector
counterclockwise (camera screen facing you) to
firmly attach.
To remove the camera cable, turn the connector
clockwise (direction of arrow).
Additional camera cable and extensions are available
at additional cost. Consult your dealer for further
information.
Hook and magnet (fig. 6)
dCt410
The hook is beneficial for retrieving cable or wire
located in tight spaces. The magnet is beneficial for
retrieving metal objects in tight spaces.
To attach the hook or magnet, turn the knurled part
of the camera counterclockwise until it stops.
Align the hook or magnet with the gray groove (t)
then slide it down until the tabs (u) at the top of the
10
hook/magnet are securely in the notches (v) located
in the camera lens.
Turn the knurled part clockwise to lock the base of
the hook and magnet.
Hook, magnet and mirror (fig. 7, 8)
dCt411
Follow the process below to assemble the hook,
magnet or mirror onto the DCT411 9 mm camera.
WALT battery
e
1. With the sleeve (w) on the accessory, insert the
2. Make sure the accessory is in the groove (y) on
Belt Hook (fig. 9)
(optional accessory)
iMPoRTANT: When attaching or removing the belt
hook, use only the screw (z) that is provided.
The belt hook (aa) can be attached to either side
of the tool using only the screw (z) provided, to
accommodate left- or right-handed users. If the
hook is not desired at all, it can be removed from
the tool.
To move belt hook, remove the screw (z) that holds
the belt hook in place then reassemble on the
opposite side.

operation

instructions for Use
inserting and removing the
Battery pack from the inspection
Camera (fig. 10)
bottom of accessory (bent wire) into the hole (x)
in the 9 mm camera cable.
the sleeve and slide the sleeve onto the camera
until the sleeve covers the hole (x).
CAUTION: Cut Hazard. Use care when
handling hook.
WARNING: To reduce the risk of
serious personal injury, DO NOT
suspend camera overhead or suspend
objects from the belt hook. ONLY hang
camera's belt hook from a work belt.
WARNING: To reduce the risk of
serious personal injury, ensure the
screw (z) holding the belt hook is
secure.
WARNING: Always observe the safety
instructions and applicable regulations.