Screw adjuster foot to fine tune the horizontal
angle.
To retract the foot, hold up the projector then
slowly lower the projector. Screw the adjuster foot
in a reverse direction.
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes
trapezoidal. To correct this situation, see
"Correcting 2D Keystone" on page 27
•
Do not look into the lens while the lamp is on. The
strong light from the lamp may cause damage to
your eyes.
•
Be careful when you press the adjuster button as it is close to the exhaust vent where hot air
comes from.
26
Operation
for details.