Olympus CAMEDIA C-2 ZOOM Reference Manual page 100

The batteries ran out of
power during shooting
or while the images
were being written to
the card. (Only the
battery check indicator
blinks.)
The memory gauge is
full.
A write-protect seal is
attached to the card.
There is a problem with
the card.
The flash does not fire.
Possible cause
The flash has not
popped up fully.
The flash is set to the
flash off mode.
The subject is
illuminated.
Sequential shooting or
movie mode is set.
Panorama mode is set.
The monitor is not clear.
Possible cause
The brightness is not
adjusted properly.
The monitor is exposed
to direct sunlight.
Replace the batteries with new ones. If the
orange lamp is blinking, wait until it stops.
Wait until there is room in the memory gauge.
Insert a new card or remove the write-protect
seal.
Refer to "Error codes".
Corrective action
Be careful not to press the flash down with your
finger. Make sure it has popped up fully before
taking pictures.
Select a flash mode other than flash off.
If you want the flash to fire, set the flash to fill-in
mode.
The flash does not fire in sequential shooting or
movie mode. Set
The flash does not fire in panorama mode. Close
the lens barrier, then open it again.
Corrective action
Select in the mode menu and then adjust
the brightness.
Block the sunlight with your hand.
in the DRIVE menu.
Troubleshooting
p.9
p.9
p.14
p.96
Ref. Page
p.42
p.42
p.42
p.35, 46
p.56
Ref. Page
p.88
–
99