The Computer Won't Connect; I Can't Connect To The Internet; The Schedule Recording/Timeshift Function Isn't Working - Samsung KR-X14ATSCH-1 E-Manual

The computer won't connect.

There is something wrong
with the TV.
The "Mode Not Supported"
message appears.
The video is OK but there is
no audio.

I can't connect to the Internet.

There is something wrong
with the TV.
The wireless network
connection failed.
The software update over
the Internet has failed.
The Schedule Recording/Timeshift function isn't
working.
There is something wrong
with the TV.
The TV cannot recognize the
Format
USB device or the
Device, Check Device
Device Performance Test.
There is a message saying I
need to format the USB storage
device.
Schedule Recording
cannot be
used.
I get a performance test failure
Schedule
message and then
Recording
and the Timeshift
operation stops working.
Try this!
Set your PC's output resolution so it matches a resolution supported by the TV.
If you are using an HDMI connection, check the audio output setting on your PC.
If you are using a DVI to HDMI cable, a separate audio cable is required.
Try this!
Make sure the TV is connected to a wireless IP router.
Check the network connection status.
If the TV is not connected to a network, connect to a network.
The upgrade stops if you already have the latest software version.
Try this!
Refer to the USB device's manual and see if data can be stored on it.
Check if the USB device is in a locked state.
Check if the USB device was formatted when it was connected to a computer.
Formatting a USB device after connecting it to the TV may result in a formatting
and
Device Performance Test
failure. If
a problem with the USB device or its specifications. Try using a different USB
device.
Check if the USB device is in a locked state.
Use the USB recovery function to recover the USB device.
Check if there is a USB device connected to the TV.
Check if the channel is a digital channel that can be recorded. Recording will
automatically stop if the signal becomes too weak. The Timeshift function will
not work if there isn't enough storage space on the USB device.
This problem can occur when using a low-performance USB storage device
that does not support recording. A USB hard drive with a speed of 5,400rpm or
above is recommended. A USB memory Stick is not supported.
Format Device
or has failed, there may be