Contec AIO-160802LI-PE User Manual page 90

AO-1604LI-PE
Table 6.3. Specification
Item
Analog output
Isolated specification
Number of output
channels
Output range
Absolute max. output
currency
Output impedance
Resolution
Non-Linearity error *1
Conversion speed
Buffer memory
Conversion start trigger
Conversion stop trigger
External start signal
External stop signal
External clock signal
Digital I/O
Number of input channels
Number of output channels
Counter
Number of channels
Counting system
Max. count
Number of external inputs
Number of external outputs
Response frequency
Common section
I/O address
Interruption level
Connector
Power consumption
Operating condition
Bus specification
Dimension (mm)
Weight
*1: The non-linearity error means an error of approximately 0.1% occurs over the maximum range at 0 ° C and 50 ° C
ambient temperature.
*2: SPS = Samplings Per Second. The number of data that can be converted in one second is shown.
Board Dimensions
169.33(L)
AIO-160802LI-PE, AI-1616LI-PE, AO-1604LI-PE
Bus-Isolated
4ch
Bipolar ± 10V
± 5mA
1 Ω or less
16bit
± 5LSB
10 μ sec [100KSPS]*2
1k Word
Software / external trigger
Number of sampling times / external trigger/software
TTL-level (Rising or falling edge can be selected by software)
Digital filter (1 μ sec can be selected by software)
TTL-level (Rising or falling edge can be selected by software)
Digital filter (1 μ sec can be selected by software)
TTL-level (Rising or falling edge can be selected by software)
Unisolated input 4ch (TTL-level positive logic)
Unisolated input 4ch (TTL-level positive logic)
1ch
Up count
FFFFFFFFh (Binary data,32bit)
2 TTL-level (Gate/Up)/ch
Gate (High level), Up (Rising edge)
TTL-level
Count match output (positive logic, pulse output)
1MHz (Max.)
64 ports
Errors and various factors, One interrupt request line as INTA
10250-52A2JL[3M]
3.3VDC 1150 mA (Max.)
0 - 50 ° C, 10 - 90%RH (No condensation)
PCI Express Base Specification Rev. 1.0a x1
169.33 (L) x 110.18(H)
120 g
The standard outside dimension (L) is
the distance from the end of the board to
the outer surface of the slot cover.
[mm]
Specification
6. About Hardware
83