Toshiba QOSMIO G50 Maintenance Manual page 277

4.14 Touch pad/Fingerprint sensor board/LED board
Installing the touch pad/Fingerprint sensor board/LED board
The following describes the procedure for installing the touch pad/fingerprint sensor
board/LED board (See Figure 4-26 to 4-30).
NOTE: When using a new touch pad, stick the insulator (T-PAD BACK INSULATOR)
Insulator (T-PAD BACK INSULATOR)
1. Connect the touch pad cable to the connector on a new touch pad.
2. Stick the touch pad to the slot of the cover assembly in place.
3. Set the plate to the LED board and secure them with the following screw.
•
4. Set the LED board to the touch pad plate and secure them with the following
screws.
•
5. Set the Fingerprint sensor board to the LED board and secure them with the
following screw.
•
6. Connect the Fingerprint sensor board cable to the connector on the Fingerprint
sensor board.
7. Set the Fingerprint sensor board/LED board to the guides of the cover assembly
and secure it with following screws.
•
8. Connect the touch pad cable to the connector on the Fingerprint sensor board/LED
board.
9. Connect the touch pad SW/LED cable to the connector on the LED board and
arrange the LED board cable under the guides of the cover assembly.
10. Stick the glass tape and aluminum tape (AL TAPE LED FFC) in place.
QOSMIO G50 Maintenance Manual (960-683)
Downloaded from LpManual.com Manuals
on the touch pad.
M2.5×2.8B FLAT HEAD screw
M2.5×2.8B FLAT HEAD screw
M2.5×2.8B FLAT HEAD screw
M2.0×4B BIND screw
4 Replacement Procedures
Touch pad
×1
×2
×1
×2
[CONFIDENTIAL] 4-47