Oki ES1624n MFP User Manual page 92

8. Identify the RAM expansion slot (1) in the machine.
9. The RAM expansion slot already contains a memory board. It
will have to be removed before you can install the new one.
To remove it proceed as follows:
(a) Identify the locking clips (2) at each end of the RAM
expansion slot (1).
(b) Push the clips outward and back into the machine. The
board will pop out slightly.
(c) Grip the board firmly by its short edges and pull it out
of the slot.
(d) Place the removed memory board in the antistatic bag
which originally contained the new memory board.
10. Hold the new memory board by its short edges, so that the
edge connector faces in towards the RAM expansion slot, and
the small cutout is closer to the bottom of the machine.
11. Gently push the board into the RAM expansion slot until it
latches in and will not go any further.
12. Locate the three retaining clips at the bottom of the side
cover into their rectangular holes near the bottom of the
machine.
13. Close the top of the side cover up to the printer and refit the
securing screw removed in step 4.
1
2
ES1624n MFP User's Guide
Installing upgrades • 92
2