JVC KW-XG701 Instructions Manual page 38

Symptom
• Bluetooth device does not detect the unit.
• The unit does not detect the Bluetooth device. • Check the Bluetooth setting of the device.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped during
playback of a Bluetooth audio device.
• The connected audio device cannot be
controlled.
• "NO DISC" appears on the display.
• "NO MAG" appears on the display.
• "RESET 8" appears on the display.
• "RESET 1" – "RESET 7" appears on the display. Press the reset button of the CD changer.
• The CD changer does not work at all.
* For Bluetooth operations, refer also to the instructions supplied with the Bluetooth Adapter.
Downloaded from Caradio-Manual.com Manuals
38
Remedy/Cause
The unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
• Search from the Bluetooth device. After the device
detects the unit, select "OPEN" on the unit to connect
the device. (See page 14.)
• Enter the same PIN code for both the unit and target
device.
• Select the device name from "SPECIAL," then try to
connect again. (See page 15.)
Adjust the microphone unit position.
• Reduce the distance between the unit and the
Bluetooth audio device.
• Move the car to a place where you can get a better
signal reception.
• Reduce the distance between the unit and the
Bluetooth audio device.
• Disconnect the device connected for "BT-PHONE."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the
device again.
Check whether the connected audio device supports
AVRCP (Audio Video Remote Control Profile).
Insert a disc into the magazine.
Insert the magazine.
Connect this unit and the CD changer correctly and press
the reset button of the CD changer.
Reset the unit (see page 3).