JVC HX-D7 Service Manual page 11

3.1.9 Removing the 5DVD changer mechanism assembly
(See Figs.15 to 19)
• Remove the metal cover, rear panel, video board and amplifier
board.
(1) From the right side of the main body, remove the card wire
from the sections g of the shield. (See Fig.15.)
(2) From the left side of the main body, remove the wire from
the sections h of the shield. (See Fig.16.)
(3) From the both sides of the main body, remove the four
screws K and remove the shield from the main body. (See
Figs.15 and 16.)
(4) Disconnect the wires from the connectors (DCW02,
DCW04, DCW05) on the DVD power board. (See Fig.17.)
(5) From the both sides of the main body, remove the four
screws M and remove the 5DVD changer mechanism as-
sembly from the main body in the direction of the arrow.
(See Figs.17 and 18.)
(6) Disconnect the card wire from the connector
forward side of the main board. (See Fig.18.)
(7) From the top side of the 5DVD changer mechanism as-
sembly, remove the four screws N and remove the base 1
and base 2. (See Fig.19.)
(8) From the bottom side of the 5DVD changer mechanism as-
sembly, disconnect the card wire from the connector
CN701 on the DVD servo control board. (See Fig.19.)
Reference:
When removing the tray panels, release the claws j of the tray
panel and remove the five tray panels from the 5DVD changer
mechanism assembly. (See Fig.19.)
Note:
When releasing the claws j, take care not to break them. (See
Fig.19.)
CW104 on the
M
g
K
Fig.15
Shield
h
K
Fig.16
5DVD changer mechanism assembly
DCW05
DCW02
DVD power board
Fig.17
Shield
DCW04
(No.MB455)1-11