Si Joystick Switch Replacement; Si Support Pad For Camera Switch - Sony Ericsson K800 Electrical Repair Manual

SI-Joystick Switch Replacement
Instruction:
It is very important to avoid that you get fl ux remains inside the
joysticks contact surfaces in order to avoid re-repair!
When you replace a joystick switch you MUST:
1. Avoid using extra fl ux!
2. Do not clean the area around the joystick with alcohol or similar. It will dissolve fl ux on
the PCB and bring it into the joystick switch if you are not very careful.
Watch the joystick replacement movie on CSPN:
CSPN/ Repair instructions/ Standard/[product] (ex. K800) /
JOYSTICK SWITCH MOVIE GENERAL
JOYSTICK SWITCH MOVIE GENERAL
JOYSTICK_SWITCH_MOVIE_GENERAL.PKZIPV2R04.zip
Reference number: 15365-61602
Created: 2007-05-09
Patrik Cesar (patrik.cesar@ecs.ericsson.se)
Author:
APPENDIX SI Joystick Switch Replacement - Support Pad for Camera Switch
SI-K800/K790 SI-Support Pad for Camera Switch
Background:
We have seen some cases reported that the shutter function doesn't work, i.e. the camera is not
activated / deactivated by it.
This can be caused by that the camera switch tilts up a little due to incorrect assembly.
From Production week 06W26 a support pad was added in the antenna cover to prevent these
problems at assembly.
Instruction:
If you order new antenna covers you will get this support pad attached to the antenna cover.
If you have old antenna covers without these or get in units produced earlier than W626 we will
make this support pad available as a spare part so you can add it to them to prevent any problems
during assembly. It is expected within a few weeks. There will be an update when they are
available.
Reference number: 14861-57674
Created: 2006-10-19
Patrik Cesar (patrik.cesar@ecs.ericsson.se)
Author:
SEMC Electrical Repair Manual
Support pad on the antenna cover.
K800 - K810
1202-3085 rev. 2 116 (121)