Siemens KA58NA75 Installation Instructions And Instructions For Use page 21

Refrigerator compartment door is
deeper:
If the previous steps for aligning
the door are not adequate:
S Remove the base panel.
S Loosen 3 hinge screws. Do not
completely unscrew the screws!
S Place the wrench on the adjusting
screw.
- To raise a door:
Rotate the wrench clockwise.
- To lower a door:
Rotate the wrench
anti clockwise.
Downloaded from Fridge-Manual.com Manuals
Note:
Due to the weight of the appliance and
the food load in the door, the refrige
rator compartment door may incline,
even if the appliance itself is level.
The door gap is not the same at the top
and bottom.
S Remove the upper hinge cover (1).
S Loosen hinge screws (2). Do not
completely unscrew the screw!
S Adjust the inclination of the
refrigerator compartment door.
S Tighten the hinge screws.
S Fix the hinge covers.
Switching on
the appliance
Switch on the appliance according to
the enclosed operating instructions.
Disconnecting
the appliance
Disconnect the appliance according to
the enclosed operating instructions.
If the appliance is to be disconnected
or stored at temperatures below
freezing point, empty the water tank for
the drinking water dispenser.
Emptying the water tank in
the appliance
S Pull out the mains plug.
S Cut off the water supply to the
appliance.
S Remove the motor compartment
cover from the rear of the appliance.
S Unscrew the connecting cable (1).
S Place a shallow water collecting tray
(capacity approx. 3 litres) under the
connection valve.
S Unscrew, drain and screw back
hose (2) and then hose (3) on the
appliance connection valve.
Important: Do not mix up the hose
connections!
S After draining the water tank, re
attach the motor compartment cover.
Switch on the appliance and then
turn on the tap.
en
21