Table of Contents
Advertisement
Keep the battery out of reach of chil-
y
y
dren.
- This may result in personal injury or
damage to the product.
Make sure that the battery is installed
y
y
correctly.
Incorrect battery replacement may
y
y
cause fire.
CAUTION
Unplug the power cord if the projec-
y
y
tor is not used for a long period.
- Accumulated dust may cause
overheating, an electric shock from
corroded insulation and a fire from an
electrical surge.
Only use the specified type of battery.
y
y
- Otherwise, this may cause an elec-
tric shock caused by overheating
and leakage.
Make sure you use the same type of
y
y
battery when replacing.
(Battery CR2032/3 V)
In the case of a battery contact
failure, the battery may drain quickly
or the remote control may not work
properly.
SAFETY INSTRUCTIONS
ANTENNA
Outdoor Antenna Grounding
If an outdoor antenna is installed,
y
y
follow the precautions below. An
outdoor antenna system should not
be located in the vicinity of overhead
power lines or other electric light or
power circuits, or where it can come
in contact with such power lines or
circuits as death or serious injury can
occur. Be sure the antenna system
is grounded so as to provide some
protection against voltage surges and
built-up static charges. Section 810
of the National Electrical Code (NEC)
in the U.S.A. provides information
with respect to proper grounding of
the mast and supporting structure,
grounding of the lead-in wire to
an antenna discharge unit, size of
grounding conductors, location of
antenna discharge unit, connection
to grounding electrodes and
requirements for the grounding
electrode.
Antenna grounding according to the
National Electrical Code, ANSI/NFPA
70
Ground Clamp
Electric Service
Equipment
Ground Clamp
NEC: National Electrical Code
9
Antenna Lead in Wire
Antenna Discharge Unit
(NEC Section 810-20)
Grounding Conductor
(NEC Section 810-21)
Power Service
GroundingElectrode
System (NEC Art 250,
Part H)
Advertisement
Table of Contents
