Technical Data - Hilti SFC 22 A Operating Instructions Manual

LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
-
NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs flash, please refer to the information given in the Troubleshooting section.
3.5 Overload and overheating protection
The power tool is equipped with an electronic protection system to prevent overloading and overheating. The power
tool switches itself off automatically in the event of overloading and overheating. After releasing the control switch, the
power tool may not restart immediately when the switch is pressed again (while the power tool is cooling down).

4 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA
procedure 01/2003
Speed in 1st gear (with B 14/3.3 or
B 22/2.6(01))
Speed in 2nd gear (with B 14/3.3 or
B 22/2.6(01))
Torque with tool set to drilling sym-
bol (soft/flexible joint)
Torque range (15 settings)
Drilling diameter range
Keyless chuck clamping range, ⌀
Drilling diameter range in wood (soft), ⌀
Drilling diameter range in wood (hard), ⌀
Drilling dia. range in metal, ⌀
NOTE
The sound pressure and vibration values given in these instructions have been measured in accordance with a
standardized test and may be used to compare one electric tool with another. They may be used for a preliminary
assessment of exposure. The data given represents the main applications of the electric tool. However, if the electric
tool is used for different applications, with different accessories or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period. An accurate estimation of exposure should also take
into account the times when the tool is switched off, or when it is running but not actually being used for a job. This
may significantly reduce exposure over the total working period. Prescribe additional safety measures to protect the
operator from the effects of noise and/or vibration, such as: maintaining the tool and accessories, keeping the hands
warm, reorganization of work patterns.
LEDs blink
-
-
-
-
LED 1
LED 1
SFC 14‑A
14.4 V
1.5 kg
0...500/min
0...1,700/min
Max. 24 Nm
1.5...10 Nm
1.5...13 mm
1.5...20 mm
1.5...12 mm
1.5...10 mm
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
The battery has overheated
SFC 22‑A
21.6 V
1.7 kg
0...600/min
0...1,800/min
Max. 28 Nm
1.5...10 Nm
en
15