Starting Interactive Presentation Utility; Performing Calibration (Position Alignment); Changing The Settings - Sony VPL-SW535C Quick Reference Manual

1
Insert the supplied CD-ROM into the
CD-ROM drive of the computer.
Open the CD-ROM and double-click
[InteractivePresentationUtility.exe].
Note
Close all running applications, then start the
installation.
2
Follow the on-screen instructions to
install the software.
To uninstall Interactive Presentation
Utility, click [Start]-[All Programs]-
[Interactive Presentation Utility]-
[Uninstall].
Starting Interactive
Presentation Utility
To start Interactive Presentation Utility, click
[Start]-[All Programs]-[Interactive
Presentation Utility]-[Interactive
Presentation Utility].
After the application starts, an icon appears
in the taskbar.
Projector connected to computer.
Projector not connected to computer.

Changing the Settings

Click the icon in the taskbar to display the
pop-up menu.
Minimize
Save setting
Calibrate
Information
Exit
Minimize: Minimize toolbar
Save setting: Select a folder to save image
files and file format.
Calibrate*: Start Calibration (page 18)
18
GB
Using Interactive Function
Information: Display information about
Interactive Presentation Utility.
Exit: Close Interactive Presentation Utility.
* Appears in the pop-up menu when your
computer is connected to the projector.
Performing Calibration
(Position alignment)
Use the supplied USB cable to connect the
projector to the computer. Double-click the
icon in the taskbar, then select [Calibrate].
Calibration is the operation to align the pen
position on the projection surface with the
mouse position on the computer screen. Be
sure to perform calibration when using the
Interactive function for the first time.
Changing resolution or moving the projector
may offset the current calibration. In this
case, perform calibration again.
Calibration (Position alignment)
A flashing dot appears in the top left of the
screen.
Touch the center of the dot with the tip of the
Interactive Pen Device until the dot stops
flashing.
The dots appears from the top left to bottom
right of the screen. Repeat the above for all
dot positions to complete calibration.
Note
Make sure you touch the center of the dot,
otherwise positioning may be offset.