Toshiba MML-AP0071BH Installation Manual page 8

3
INSTALLATION OF INDOOR UNIT
1. Remove foamed polystylene cushion for protection
during transportation, which is entered under left/
right side plate of the main unit and electric parts
box.
Also, when installing the unit, remove tape for
transportation adhered to the electric parts box.
2. Install the indoor unit before lining the wall.
Fixing of unit
Fix the indoor unit to the floor and wall by attaching two or four M8 anchor bolts to the position in the following figure
to tighten and fix with nut utilizing holes at left/right side plates.
In case of fixing indoor unit to floor
<Indoor unit viewed from overhead>
A
B
Model MML-
AP0071BH to AP0121BH
AP0151BH to AP0241BH
* Attach and fix the electric parts box to the wall under
condition that electric parts box to be attached to the
side face is removed. Remove the electric parts box
as follows.
<How to remove the electric parts box>
1. Remove two mounting screws at upper side of the
electric parts box.
2. Slide the electric parts box to the arrow mark (
and remove it from the set.
Electric parts box
mounting screws
(2 pcs)
Electric parts box
(Front side)
A B
580 610
880 910
ñ
Tape for transportation
Electric parts box
Foamed polystylene cushion
(Both left and right)
In case of fixing indoor unit to wall
<Indoor unit viewed from front side>
AP0071BH to AP0121BH
AP0151BH to AP0241BH
Installation of remote controller
(Sold separately)
),
For installation of the wired remote controller, follow
the Installation Manual attached with the remote
controller.
For installation of the wireless remote controller, follow
to the Installation Manual attached to the remote
controller.
• Do not put the remote controller on the place where
is exposed to direct sunlight or near a stove, etc.
• Operate the remote controller, check the indoor unit
surely receives the signal, and then install the
remote controller. (Wireless type)
• Install the remote controller 1m apart from the
devices such as TV or stereo. (Image may be
disturbed or noise may be output.) (Wireless type)
5
(Floor)
A
Hole is provided
B
to rear side.
Model MML-
580
880
A B
610
910