Repair And Maintenance - Razor RSF650 Owner's Manual

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
Adjusting the Brakes
Tools required: 5 mm Allen wrench
1
To adjust brake cable play,
thread the brake lever adjuster
in or out 1/4 to 1/2 turn until
the desired brake adjustment is
attained. Most adjustments are
complete at this step. If brake still
needs further adjustment, proceed
to step 2.
Replacing the Fuse
Tools required: Phillip screwdriver, 4 mm Allen wrench
4mm Allen
Phillip
Phillip
bolt
screw
screw
Phillip
screw
Phillip
screw
1
Loosen the 4mm Allen bolt and
the four (4) Phillip screws on the
battery cover. Remove Cover.
3
Close fuse box.
• Secure the product under repair
• Exercise caution around
exposed parts
2
If the brake has too much
slack, loosen the rear anchor
bolt with a 5 mm Allen wrench
and pull the brake wire tighter.
The distance of the brake wire
between the end of the cable and
the anchor bolt should be between
37 mm and 44 mm.
2
Locate the fuse box attached to the batteries.
Check fuse to see if the fuse is burnt out.
Remove damaged or burnt fuse and replace
with a new one of equal amperage.
Note: Amperage is located on top of fuse.
4
Re-attach battery cover.
• Contact Razor customer service
if unsure about any repair or
maintenance
3
If the disc brake is dragging on
the brake pads, use your fingers to
twist the caliper adjuster in either
direction until disc is centered
between the brake pads.
Amperage
number
6
WARNING: The brake
is capable of causing the electric
motor bike to skid the tire throwing
an unsuspecting rider. Practice in
an open area free from obstacles
until you are familiar with the brake
function. Avoid skidding to a stop as
this can cause you to lose control or
damage the tires.
Testing the Brakes. To use
the brakes, squeeze the levers
to increase the pressure on
the brake. The brake levers are
fitted with a cable adjuster to
compensate for cable stretch and/
or to fine-tune the lever movement
to brake engagement. If brakes
are not engaging properly, follow
instructions for adjusting the brakes.
WARNING: To prevent
shock, please follow the instructions
accordingly and do not skip any steps.