Replacing The Lamp - Electrolux ENN2800BOW User Manual

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.

6.1 Replacing the lamp

CAUTION!
Disconnect the plug from the
mains socket.
1
2
1
Possible cause
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regulator
is not set correctly.
1. At the same time, with the fingers ex-
pand up and down the transparent cov-
er and unhook it in the direction of the
arrows.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maximum
power is shown on the light bulb cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5.
Open the door. Make sure that the light
comes on.
ENGLISH
Solution
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
11