Related Manuals for Electrolux ENN2801AOW
Summary of Contents for Electrolux ENN2801AOW
- Page 1 ..ENN2801AOW EN FRIDGE-FREEZER USER MANUAL...
-
Page 2: Table Of Contents
ENVIRONMENT CONCERNS ........... . 25 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. -
Page 3: Safety Information
SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and acci- dents, it is important to ensure that all peo- ple using the appliance are thoroughly fa- miliar with its operation and safety features. -
Page 4: Daily Use
If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. You must not operate the appliance without the lamp cover (if foreseen) of interior lighting. • This appliance is heavy. Care should be taken when moving it. - Page 5 ENGLISH ENVIRONMENT PROTECTION This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam con- tains flammable gases: the appli- ance shall be disposed according to the applicable regulations to ob-...
-
Page 6: Operation
OPERATION SWITCHING ON Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting. SWITCHING OFF To turn off the appliance, turn the Temper- ature regulator to the "O" position. TEMPERATURE REGULATION The temperature is automatically regulated. -
Page 7: Daily Use
DAILY USE CLEANING THE INTERIOR Before using the appliance for the first time, wash the interior and all internal accesso- ries with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. -
Page 8: Movable Shelves
MOVABLE SHELVES POSITIONING THE DOOR SHELVES HUMIDITY CONTROL The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. To permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. -
Page 9: Helpful Hints And Tips
HELPFUL HINTS AND TIPS HINTS FOR ENERGY SAVING • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run contin- uously, causing frost or ice on the evap- orator. -
Page 10: Care And Cleaning
10 www.electrolux.com CARE AND CLEANING CAUTION! Unplug the appliance before carry- ing out any maintenance operation. This appliance contains hydrocar- bons in its cooling unit; mainte- nance and recharging must there- fore only be carried out by author- ized technicians. - Page 11 PERIODS OF NON-OPERATION When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from elec- tricity supply • remove all food • defrost (if foreseen) and clean the appli- ance and all accessories •...
-
Page 12: What To Do If
12 www.electrolux.com WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or com- petent person must do the trouble- shooting that is not in this manual. Problem The appliance does not operate. - Page 13 Problem Possible cause Water flows on the The melting water outlet ground. does not flow in the evapo- rative tray above the com- pressor. The temperature in The temperature regulator the appliance is too is not set correctly. low. The temperature in The temperature regulator the appliance is too is not set correctly.
-
Page 14: Replacing The Lamp
14 www.electrolux.com REPLACING THE LAMP CLOSING THE DOOR Clean the door gaskets. If necessary, adjust the door. Refer to "Installation". If necessary, replace the defective door gaskets. Contact the Service Center. Disconnect the mains plug from the mains socket. Remove the screw from the lamp cov- Remove the lamp cover (refer to the il- lustration). -
Page 15: Installation
INSTALLATION WARNING! Read the "Safety Information" care- fully for your safety and correct op- eration of the appliance before in- stalling the appliance. POSITIONING Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Cli- Ambient temperature... -
Page 16: Door Reversibility
16 www.electrolux.com WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. DOOR REVERSIBILITY The door of the appliance opens to the right. To open the door to the left, do these steps before you install the appliance. -
Page 17: Ventilation Requirements
VENTILATION REQUIREMENTS min. 5 cm 200 cm INSTALLING THE APPLIANCE CAUTION! Make sure that the mains cable can move freely. The airflow behind the appliance must be sufficient. min. 200 cm Do these steps. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. - Page 18 18 www.electrolux.com 4 mm 44 mm Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the op- posite side of the hinge.
- Page 19 Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in oppo- site case. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge.
- Page 20 20 www.electrolux.com ca. 50 mm ca. 50 mm Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Install the part (Ha) on the inner side of the kitchen furniture. 90° 21 mm 90° 21 mm Push the part (Hc) on the part (Ha).
- Page 21 Open the appliance door and the kitchen furniture door at an angle of 90°. 8 mm Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the brackets and mark a distance of 8 mm from the outer edge of the door 8 mm where the nail must be fitted (K).
- Page 22 22 www.electrolux.com Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly.
-
Page 23: Noises
ENGLISH NOISES There are some sounds during normal run- ning (compressor, refrigerant circulation). HISSS! BRRR! BRRR! BRRR! BLUBB! BLUBB! -
Page 24: Technical Data
24 www.electrolux.com TECHNICAL DATA Dimension of the recess Rising Time Voltage Frequency The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. HISSS! SSSRRR! CRACK! Height Width Depth... -
Page 25: Environment Concerns
ENVIRONMENT CONCERNS Recycle the materials with the symbol Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol the household waste. - Page 26 26 www.electrolux.com...
- Page 27 ENGLISH...
- Page 28 222301057-A-462011...