Jensen JDVD1500 Installation And Operation Manual page 7

2. Carefully unsnap the plastic
trim ring from the front of the
new radio chassis. Remove
and discard the trim ring.
3. Remove the factory
mounting brackets and
hardware from the existing
radio and attach them to the
new radio. Select a position
where the screw holes of the
bracket and the screw holes
of the main unit are aligned
(are fitted). Tighten the
screws at 2 places on each side. Do not exceed M5 x 9 MM maximum screw size. Longer
screws may damage components inside the chassis.
4. Wire the new radio to the vehicle as outlined in the Universal Installation instructions.
5. When wiring is complete, reconnect the battery negative terminal.
6. Mount the new radio assembly to the dashboard or center console using the reverse
procedure of step 1.
NOTE: The mounting box, outer trim ring, and half-sleeve are not used for DIN rear
mount.
Removing the Unit (DIN Front Mount)
To remove the radio after installation:
1. Insert fingers into the groove in the front of frame and pull out
to remove the frame.
(When re-attaching the frame, point the side with a groove
downwards and re-attach.)
2. Insert the removal keys straight back
until they click, and then pull the
radio out. If removal keys are
inserted at an angle, they will not
lock properly to release the unit.
5
JDVD1500