Table of Contents
Advertisement
Section 4 - Configuration
Select 1483 MER.
Channel Mode:
VPI:
Virtual path identifier (VPI) is the virtual path between two points
in an ATM network. Its valid value is between 0 and 255. Enter the
correct VPI provided by your ISP.
VCI:
Virtual channel identifier (VCI) is the virtual channel between two
points in an ATM network. Its valid value is between 32 and 65535.
Enter the correct VCI provided by your ISP.
Encapsulation:
Select the type of encapsulation your ISP uses, either Logical Link
Control (LLC) or Virtual Circuit Multiplexing (VC-Mux).
Enable NAPT:
Check this box to enable NAT, which allows devices on your
network to share one public IP address.
Enable IGMP:
Check to enable IGMP Multicast.
802.1q:
Choose to either Disable or Enable the use of VLANs.
VLAN ID(1-4095):
If you enabled 802.1q, enter the VLAN ID.
IP Protocol:
Select the type of IP addressing: IPv4/v6, IPv4, or IPv6. This will
effect the WAN IP Settings and WAN IPv6 Settings.
PPP Settings:
1483 MER does not support PPP authentication.
WAN IP Settings:
Configure the IPv4 WAN settings. If the IP Protocol is set to IPv6,
these settings are unavailable.
Type:
Choose either Fixed (Static IP), or Dynamic IP.
D-Link DSL-2745 Wireless N300 ADSL2+ Modem Router User Manual
WAN CONFIGURATION
1483 MER Mode
34
Hide quick links:
Advertisement
Table of Contents
