Assembly; Step One: Attach Gauge; Step Two: Attach Gun Hose To Spray Gun And Pump; Step Three: Attach Gun Clips To Tank - North Star M268180M Owner's Manual

Step One: Attach gauge

1. Remove and discard the plug in the gauge port.
2.
Thread in pressure gauge. Hand tighten, then turn 2 full turns with a wrench.

Step Two: Attach gun hose to spray gun and pump

1. Install hose clamps on hose.
i) Slide hose clamp over the end of the hose.
ii) Push the hose onto the hose barb.
iii) Slide the hose clamp over the hose barb.
iv) Tighten the hose clamp
2. Using 2 hose clamps, attach one end of the gun hose to the pump hose barb.
3. Using 2 hose clamps, attach the other end of the gun hose to the spray gun.
Gun hose
Hose clamps
Spray gun

Step Three: Attach gun clips to tank

Fasten one gun clip and one large gun clip to the sprayer tank with #10 x 1/4" screws.

Step Four: Attach drain cap to tank

Press the rubber washer into the drain cap with your finger and thread the drain cap onto the tank.
Gun clip
#10 x ¼"
Screws
Large
gun clip

Assembly

Hose clamps
0 1976
01978
9
Pressure gauge
Plug
Rubber washer
Drain cap