North Star M268180M Owner's Manual page 13

8. Connect all three
powe r cords
togethe r
9. Attach remote switch
to vehicle
10. Disconne ct afte r use
11. To disconne ct
pe rmanently
Assembly (continued)
Connect the three sprayer powe r cords toge the r.
a) Check to be sure the power switch is in the " OFF" position on the remote
switch power cord.
b) Connect the one end of the remote switch power cord to the battery power
cord and the other end to the pump power cord.
To Battery
Remote switch
power cord
Pump power cord
Using supplie d velcro pads, affix remote switch to vehicle in a position that is
easily reache d from the drive r's seat.
AFTER EACH USE, disconnect powe r to the spraye r by disconnecting the
sprayer's remote switch power cord from the battery power cord – the battery
power cord may remain connected to the battery.
NOTE: It is important to disconnect power to the sprayer when not in use,
both for safety reasons and to prevent the pump from draining the battery.
ALWAYS verify that the power has been disconnected before servicing the
sprayer.
When it is necessary to disconne ct the spraye r's battery powe r cord from the
batte ry, use the following proce dure:
1. Disconnect sprayer's remote switch power cord from the battery power cord.
2. Disconnect the battery power cord from the vehicle battery as follows:
a) Disconnect vehicle battery ground wire.
b) Disconnect the battery cord's black battery clamp or black wire
connector from the negative(-) terminal of the vehicle battery.
c) Disconnect the battery cord's red battery clamp or red wire
connector from the positive(+) terminal of the vehicle battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always connect in this sequence to avoid possible shock.
(Remember that on some vehicle models, you may need to remove the sprayer to
access the battery)
Battery power cord
13
01981