Step 14
Raise beam to vertical position as
described in the SPLITTING
OPERATION section of the manual
Slightly loosen Hose Clamp on to
the loose end of the Return line
Slide the loose end of the Return
Line onto the Return Line Fitting
Tighten Hose Clamp
Step 15
Install loose end of Hydraulic Hose
into the Swivel Fitting as shown
and tighten the fitting connection to
47 lb-ft
(No hydraulic sealant required)
Step 16
Fill log splitter with hydraulic fluid
as outlined in the Initial Unpacking
& Set-Up section of the manual.
Fill engine with SAE 10W-30 as
recommended by the engine
manufacturer
Assembly Instructions
Swivel
Fitting
45
Return Line
Hose
Clamp
Return Line
Fitting
Hydraulic
Hose
Fig 02429
Fig 02428