North Star M1108D Owner's Manual page 40

Step 1
Remove shipping crate
If there are rubber boots on the axles,
remove and discard them
Slide Wheel onto Axle with Valve Stem
facing out
Slide Outer Bearing onto Axle (outer
bearing may be shipped loose in parts bag
or loose inside wheel)
Outer bearing taper points into log splitter
Slide Wheel Washer onto Axle
Step 2
Thread Axle Nut onto Axle (hand tight)
Back Axle Nut off ¼ turn
Make sure Wheel spins freely
Insert Cotter Pin through hole in Axle
and bend it so Axle Nut cannot come
off
Make sure Wheel spins freely
Tap Dust Cap onto Wheel with a soft
faced mallet
Repeat steps 1 and 2 for the other
Wheel
Step 3
Connect Towbar to Axle/Tank
using (2) Tank Bolts and (2) Tank
nuts (already in place)
Tighten Bolts to 90 lb-ft with a
wrench
Assembly Instructions
Axle with the
Rubber Boot
Outer
Bearing
Wheel
Washer
Axle Nut
Cotter
Pin
Wheel
Axle Nut
Dust Cap
Cotter Pin
Fig 02417
40
removed
Valve Stem Out
Bolt
Axle/Tank
Wheel
Towbar