Transferring Recordings To A Computer; Resetting The Device; Changing The Fuse - Kompernass DASHCAM CR 5 A1 Operating Instructions Manual

Transferring recordings to a computer

Connect the mini-USB plug of the supplied USB cable
the camera and the USB plug to a free USB port of a switched-on computer. The
computer now recognises the device as "mass storage", the camera connects to
the computer and then the content of the SD/SDHC memory card appears as a
new drive on the computer. Now carry out the required fi le operations.

Resetting the device

If the device does not work as described in this manual or it does not respond
to your operation, use a pointed object, e.g. a paper clip, to carefully press the
switch behind the RESET opening

Changing the fuse

The car adapter
because the fuse is defective. Exchange the defective fuse for a replacement fuse
of the same type (see also chapter Technical data).
♦ To do this, pull the car adapter
♦ Open the car adapter
anticlockwise (using pliers if necessary) and removing it.
♦ Now, take the plug tip (B) from the fuse (A), remove the fuse (A) and place
it to one side.
♦ Now place the new fuse into the car adapter
the slightly protruding end of the fuse and screw the previously removed
screw insert (C) back in.
NOTE
► If the device still does not work or the fuse blows again immediately, the
device is defective. Please then contact the Service Hotline (see chapter
Service).
CR 5 A1
in the housing to restart the device.
contains a fuse. If the device does not function, it may be
out of the cigarette lighter socket.
by carefully unscrewing the ribbed screw insert (C)
to the port
, place the plug tip (B) onto
on
GB
99