User Checklist - Hoover SE71WR01 Instruction Manual

Removing a Blockage
1. Check if the Dust Container is full. If so refer to 'Emptying The Dust Container'.
2. If the Dust Container is empty, but suction is still low;
A. Do the filters need cleaning? If so refer to 'Cleaning the Washable Filters'.
B. Check if there is any other blockage in the system - Use a rod or a pole to re-
move any blockage from the tubes or hose.
C. Check for and clear any blockage in the Nozzle
Warning - If the cleaner is used for a significant period of time with a blockage, a thermal
cut out will switch the cleaner off to prevent overheating. The bag check indicator turn
green once the cleaner has switched off to signal that the thermal cut out has been ac-
tivated. If this should happen, switch the cleaner off, unplug and correct the fault. It will
take about 45 minutes for the cut out to automatically reset.
ACCESSORIES
All accessories can be fitted to the hose handle or the end of the tubes.
2 in 1 Tool combines several functions into one tool [21]:
Crevice Tool – For corners and hard to reach areas.
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas.
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet
hairs removal.[1U]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal.[1V]
IMPORTANT: Do not use the Mini Turbo Nozzles on rugs with long fringes, animal hides
and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is
rotating.
(*Certain Models Only)
4800XXXX - Sprint - Multi 5lang IM.indd 3

USER CHECKLIST

Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the Bag over-filled? Please refer to 'Cleaner Maintenance'.
• Is the filter blocked? Please refer to 'Cleaner Maintenance'.
• Is the hose or nozzle blocked? Please refer to 'Removing a Blockage'.
• Has the cleaner overheated? If so, it will take approximately 45 minutes to
automatically reset.
IMPORTANT INFORMATION
Hoover Spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Consumables
• Filter kit (pre-motor and exhaust): U57 - 35601115
Spares
• Carpet & Floor Nozzle: G123 - 35601113
• Hose: D124 - 35601114
• Pet Hair Remover Mini Turbo Nozzle: J46 - 35601116
• Allergen Remover Mini Turbo Nozzle: J47 - 35601117
Hoover Customer Helpline Service
Should any faults occur with your cleaner during the first 12 months contact the Hoover
Customer Helpline on the number below.
Tel: 08444 995 599
Email: customer.services@hoovercandy.com
Hoover have a computerised nationwide service network of over 500 engineers who will
quickly respond to your call and guarantee your repair for 12 months.
3
GB
24/09/2010 01:15:13