Table of Contents
Advertisement
9.
10.
11.
12.
When the switch completes the reset and starts operating properly, you may
continue normal operation. If the reset is unsuccessful or an error indication
appears, repeat the entire procedure. If it fails again, call Bay Networks customer
support. Please be ready to provide the service representative with the information
listed on
TokenSpeed Module Startup Failure
Symptom: The switch startup process completes successfully, but the Activity
LED blinks continually.
To resolve the problem, follow these steps:
1.
2.
If the problem persists, contact Bay Networks customer support. Please be ready
to provide the service representative with the information listed on
893-01019-A
Click on the Start button in the Software Download dialog box.
If the display returns to the Main Menu instead of displaying the "Writing to
Flash" message, the download process did not complete successfully.
If you are not prompted to reset the switch, choose Discover again.
Click on the icon for the switch and choose Download software.
When the download is complete, the following message is displayed:
Writing to Flash...
The switch begins executing the loaded switch image and prompts you to
reset the switch.
Choose Reset to verify that the downloaded image is installed properly.
page
4-1.
Check all modules in the chassis to make sure they are firmly seated and
that the retaining screws are tight.
Remove and reinsert the failing module.
Troubleshooting the TokenSpeed Module
page
4-1.
4-3
Advertisement
Table of Contents
