Bridging Point-To-Multipoint Traffic Using An Atm 1483 Pvc Using The Cli; Configuring An Ip Routing 1483 Pvc Using Device Manager - Nortel Passport 8672ATME Using Manual

Bridging point-to-multipoint traffic using an ATM 1483 PVC
using the CLI
To configure two ATM 1483 bridged PVCs using the CLI:
1 To create two VLANs by port, enter:
config vlan 2 create byport 1
2
To add ATM port (1/1) and some Ethernet ports (3/40-3/48) into the VLAN,
enter:
config vlan 2 port add 1/1, 3/40-3/48
3 To create a 1483 Null-encapsulation UBR PVC, enter
config atm 1/1 pvc create 0.100 ecn 1483-null serv
ubr
Or create a 1483 Null-encapsulation VBR PVC.
config atm 1/1 pvc create 0.100 enc 1483-null serv
vbr<PCR value>scr<SCR value> mbs<MBS value>
4
To associate the two 1483 bridged PVCs with the same VLAN, enter:
config atm 1/1 pvc 1483 bridged create 2 0.100,
0.101
The Passport 8672ATME Module directs the two ATM 1483 bridged PVCs to two
different ATM ports on the other end.

Configuring an IP routing 1483 PVC using Device Manager

In the configuration shown in
ATM 1483 PVC as the sole member of a VLAN configured for IP routing.
Chapter 6 Configuring the Passport 8672ATME Module
Figure 55, the Passport 8672ATME Module has an
Using the Passport 8672ATME Module
129