JVC KD-R775S Instruction Manual page 16

AUDIO SETTINGS
For KD-R775S
HPF OFF: All signals are sent to the front/rear speakers. ; LOW 100HZ /
MID 120HZ / HIGH 150HZ: Audio signals with frequencies lower than
100 Hz/ 120 Hz/ 150 Hz are cut off from the front/rear speakers.
FADER R06 — F06 (00): Adjusts the front and rear speaker output balance.
BALANCE * 4
L06 — R06 (00): Adjusts the left and right speaker output balance.
VOL ADJUST –15 — +06 (00): Preset the initial volume level of each source
(compared to the FM volume level). Before adjustment, select the
source you want to adjust. ("VOL ADJ FIX" appears if FM is selected.)
AMP GAIN LOW POWER: Limits the maximum volume level to 25. (Select if the
maximum power of each speaker is less than 50 W to prevent damaging
the speakers.) ; HIGH POWER: The maximum volume level is 35.
D.T.EXP ON: Creates realistic sound by compensating the high-frequency
(Digital Track components and restoring the rise-time of the waveform that are lost in
Expander) audio data compression. ; OFF: Cancels.
TEL MUTING *
5 ON: Mutes the sounds while using the cellular phone (not connected
through KS-BTA100). ; OFF: Cancels.
For KD-R670 / KD-R570 / KD-R470 / KD-R370
SPK/PRE OUT Depending on the speaker connection method, select the appropriate
setting to get the desired output. ( Speaker output settings)
* 4
This adjustment will not affect the subwoofer output.
* 5
Does not work if [BT ADAPTER] is selected for [AUX] in [SRC SELECT]. ( 4)
16
JS_JVC_KD_R775S_K_EN_7.indd 16
Speaker output settings
Select the output setting for the speakers [SPK/PRE OUT], base on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 25)
(For KD-R670)
Setting on
[SPK/PRE OUT]
FRONT
REAR/REAR Front speakers output
REAR/SUB.W Front speakers output
SUB.W/SUB.W Front speakers output
(For KD-R570 / KD-R470 / KD-R370)
Setting on
[SPK/PRE OUT]
REAR/REAR Rear speakers output
REAR/SUB.W Subwoofer output
SUB.W/SUB.W Subwoofer output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output. ( 25)
(For KD-R670 / KD-R570 / KD-R470 / KD-R370)
Setting on
[SPK/PRE OUT]
L (left)
REAR/REAR Rear speakers output
REAR/SUB.W Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available.
– [R01] is selected in [FADER] and selectable range is [R06] to [00]
Audio signal through lineout terminal
REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
Audio signal through lineout terminal
REAR/SW
Audio signal through rear speaker lead
R (right)
Rear speakers output
Rear speakers output
(Mute)
27/7/2015 3:21:56 PM