Table of Contents
Advertisement
Installing and Operating Passport ARN Routers
Using the ifconfig Command
A router interface cannot communicate in an IP network without an IP address.
Because an ARN netboots over one of its serial, 56/64K DSU/CSU, Ethernet, or
token ring links, the netboot interface must have a valid IP address.
You use the interface configuration command
•
Configure the router's initial IP interface to the network. (The initial IP
interface should be a serial interface if you are using EZ-Install.) You also use
the same procedure to configure other serial interfaces for the netbooting
procedure.
•
Configure Ethernet or token ring interfaces for the netbooting procedure.
•
Enable or disable netbooting on an interface.
Configuring an IP Serial or 56/64K DSU/CSU Interface for Netbooting
Configure a serial or 56/64K DSU/CSU (COM) interface to the IP network using
the following interface configuration command:
ifconfig [< synchronous_options> ] <interface> [ <IP_address> <subnet_mask>
[ <next_hop_address> ]]
The
settings:
|
[
-d
Note: Make sure to separate command options with spaces.
A-2
synchronous options
|
|
[
-r [56
64]
-fr
-annexd
ifconfig
variable indicates some combination of the following
|
|
-lmi
-annexa
to do the following:
|
]
]
-int_clk
114200-E Rev 00
Advertisement
Table of Contents
