Care And Maintenance - MoistAir MA0300 Instructions Manual

1) For initial operation, plug the unit in (the display will show 00). Press the speed
button once. The fan speeds cycle from high to low. The unit will initialize and begin
reading the room humidity.
2) The built-in hygrometer reads the current room humidity and displays the percentage
on the right bar graph.
3) To set the desired humidity, press the HUMIDITY button and observe the left bar
graph climb with each pressing. Each successive push increases the humidity in 10%
increments. Once it reaches the maximum, it cycles back to the beginning.
4) Press the SPEED button to adjust the fan setting. Use low setting (01) for the quietest
operation and the high (04) for maximum output.
5) TO STOP the unit, press the SPEED button for two seconds
NOTE: If excessive condensation occurs, reduce fan to a lower speed setting.
Auto Humidistat
Once the unit is on, the automatic humidistat function allows you to set the desired
humidity level and the fan speed (01 through 04), and the unit will operate until the desired
humidity level is reached. When reached, the fan will turn off.
When the humidity level drops below the set humidity, the fan will turn on automatically.

Care and Maintenance

Cleaning your humidifier regularly helps eliminate odors, bacterial and fungal growth.
Ordinary household bleach is a good disinfectant and can be used to wipe out the
humidifier base and bottle after cleaning.
We recommend cleaning your humidifier at least once a week to maintain optimum
environmental conditions from your humidifier.
We also recommend using Essick Air Bacteriostat Treatment each time you refill
your humidifier to eliminate bacterial growth. Add bacteriostat according to the
instructions on the bottle. Please call 1-800-547-3888 to order Bacteriostat Treatment
reference part number 1970.
Cleaning Instructions
1) Turn off unit and unplug from outlet.
2) Remove water bottle from the
humidifier and place it in a secure
place. Locate the two internal spring
latches on the front and rear of the
base. Releasing these latches will
allow removal of the top housing.
Flex the rear latch and lift the back of
the top housing off the base far
enough to clear the latch. Flex the
front latch and lift the complete top
housing away from
the base. Place the top housing
on a flat surface. See illustration.
Removing Scale
3) Once separated from the chassis, place the base of the unit in the top rack of a
dishwasher, or hand wash by filling with water and adding 8 oz. of white vinegar. Let
solution set for 20 minutes, then empty and rinse thoroughly.
4) Similarly, clean the bottle by filling with water and 8 oz. of white vinegar, then allow to
set for 20 minutes. Rinse thoroughly.
5) Lift the wick from the unit and let excess water drain. Rinse wick under fresh water
only. Do not use soap, detergent, or any other cleaners on the wick. Leave in sink to
drain.
Front Spring Rear Spring
Latch Latch
6