Controls And Operation - MoistAir MA0300 Instructions Manual

Filling
CAUTION: Disconnect power before filling, cleaning or servicing unit.
Keep grille dry at all times.
1) Remove water bottle and unscrew cap on bottom. Fill bottle with unsoftened water.
Replace cap and tighten securely. Use both hands to carry the bottle to the base.
NOTE: If only softened water is available, it can be
used; however you will notice a build up of minerals
on the evaporative wick much sooner.
2) While the bottle is removed from the unit, make
sure wick is resting all the way into the water
channel.
3) Return bottle to its upright position using the
handle on the top of the bottle. Set the bottle
in the recessed area with the top of the bottle
flush with the top of the humidifier. When
positioned properly, the valve will open and
water will flow into the water channel.
CAUTION: Do not spill water on fan motor. Electrical components must be kept
dry.
4) We recommend using only EPA registered bacteriostat treatment such as Essick Air
Bacteriostat, Part Number 1970 whenever you refill the humidifier to eliminate
bacterial growth. Add bacteriostat according to the instructions on the bottle.
5) Plug cord into wall receptacle.
Controls & Operation
The humidifier should be placed at least FOUR inches away from any walls and away
from heat registers. Do not place on soft carpet. Unrestricted airflow into the unit will
result in the best efficiency and performance.
Control Panel
The four-speed
digital control
allows you to
Desired
monitor room
Humidity
humidity and
Level
set target Indicator
humidity.
Power
Indication
Wick Placement
Current
Humidity
Level
Indicator
Humidity Button
5
Fan Speed
Display
Fan ON/OFF and
Fan Speed Button