Advertisement
Removing a Small Form Factor Pluggable
(SFP) GBIC
This section lists the steps for removing a GBIC.
To remove a GBIC:
Disconnect the network fiber cable from the SFP GBIC
1
connector.
Depending on your SFP GBIC model, either pull the LC
2
extraction tab located in the front of the SFP GBIC (below
right) with your thumb and forefinger, or press the button on
the botton of the MT-RJ SFP GBIC (below left).
Figure 8 Removing a SFP GBIC (Bottom view)
MT-RJ
SFP GBIC
Slide the SFP GBIC out of the Gigabit Ethernet module slot.
3
If the SFP GBIC does not slide easily from the module slot,
4
use a gentle side-to-side rocking motion while firmly pulling
the SFP GBIC from the slot.
LC SFP GBIC
21
10518FA
Advertisement
