HP FlexFabric 5930 Series Configuration Manuals page 357

setting IRF link down report delay, IRF-25
setting LAN switching LLDP frame encapsulation
format, LSW-282
setting LAN switching LLDP operating mode,
LSW-276
setting LAN switching
LSW-281
setting LAN switching LLDP reinitialization delay,
LSW-276
setting Layer 3 aggregate interface (MTU),
LSW-56
setting log minimum storage period, NM-89
setting login management Telnet login max
number concurrent users, FM-28
setting loop detection interval, LSW- 1 38
setting MAC address table dynamic aging timer,
LSW-30
setting MAC address table learning limit on
interface, LSW-30
setting MAC authentication concurrent port
users max, SEC- 1 15
setting MAC authentication timer, SEC- 1 14
setting MAC change notification interval,
LSW-40
setting MAC Information mode, LSW-39
setting MAC Information queue length, LSW-40
setting MLD snooping 802.1p message priority,
MCAST-245
setting MLD snooping 802.1p message priority
(global), MCAST-245
setting MLD snooping 802.1p message priority
(VLAN), MCAST-246
setting MLD snooping dynamic port aging
timers, MCAST-239
setting MLD snooping dynamic port aging
timers (global), MCAST-239
setting MLD snooping dynamic port aging
timers (VLAN), MCAST-239
setting MLD snooping forwarding entries max,
MCAST-238
LLDP parameters,
355
setting MLD snooping IPv6 multicast groups
max (on port), MCAST-248
setting multicast VLAN max forwarding entries,
MCAST-52
setting OpenFlow connection interruption mode,
OF- 1 4
setting OpenFlow controller mode, OF- 1 0
setting OpenFlow datapath ID, OF- 1 2
setting OpenFlow max number flow entries,
OF- 1 0
setting OpenFlow timer, OF- 1 5
setting PIM join/prune message max size,
MCAST- 1 32
setting port security mode, SEC- 1 98
setting QinQ SVLAN tag 802.1p priority,
LSW-229
setting QoS congestion management queuing,
QACL-60
setting QoS data buffer fixed-area max queue
ratio, QACL-98
setting QoS data buffer shared-area max queue
ratio, QACL-97
setting RIP packet max length, IPR-38
setting security password
parameters, SEC-219
setting security password control local user
parameters, SEC-221
setting security password control user group
parameters, SEC-220
setting security portal authentication max
number users, SEC- 1 40
setting security super
parameters, SEC-222
setting spanning tree mode, LSW- 1 00
setting SPBM LSDB overload bit, SPB-29
setting SPBM PNP link metric value (global),
SPB-20
setting SPBM PNP
(port-specific), SPB-20
setting subinterface MTU (Layer 3 Ethernet),
LSW- 1 6
control global
password control
link metric value