Nortel T7316E User's Card

Return
to Menu
T7316E Telephone User Card
1-800-4 NORTEL
www.nortelnetworks.com
© 2003 Nortel Networks
P0603479 02
Printed in Canada
Your T7316E telephone
A Telephone light
Flashes for incoming calls.
Lights up when Message Waiting Indication (MWI) is
supported by system software. Contact your system
administrator for more information.
B Adjustable tilt display
Shows the time and date, call and feature information.
Display buttons
C
The label for display buttons appear in capital letters
on the bottom of the display. Display buttons change
with each feature you use.
Contrast level 2
Feature message
DOWN UP OK
Display button label
Display button
® Release button
D
Ends an active call or feature.
E Dial pad
√ Volume control
F
Adjusts the handset, handsfree, headset and ringer
volume.
A
B
J
C
H
D
I
K
E
L
F
G
M
N
More on your T7316E telephone
G Audio cluster buttons
© Mute button
Turns the microphone off or on when you are on a call.
Handsfree button
For more information on using the handsfree feature,
refer to the "Handsfree calls" section in this card.
¬ Headset button
Turns the headset mode on.
≤ Feature button
H
Starts or ends a feature.
≥ Hold button
I
Places calls on hold.
Memory buttons
J
K Memory and line buttons
L Indicators
Appear next to active line and memory buttons.
M Number card
Write your extension number on this card.
N Feature card plate
Storage compartment for your feature card.
Cord connections
1
J
Slide feature card plate down.
K
2 Desk mount option
Route line cord through the stand.
3
Wall mount without a telephone stand
1
Press here to remove the stand.
Connect cords to the telephone,
refer to "Cord connections"
illustrations.
2
Connect line cord to
wall jack.
Place the telephone onto
the wall mount plate and
slide it down.
Wall mount with a telephone stand
1
2
Headset option
Connect cord to
Connect cords to the telephone,
headset.
Connect cord
3
to handset.
Mount the telephone
onto the screws and
slide it down.
Connect line cord
Connect line cord to
to wall jack.
wall jack.
Telephone setup
Display contrast level
Adjust the contrast of your display.
1. Press ≤•‡.
2. Press UP or DOWN to view the levels.
3. Press OK to select a level.
Language choice
≤•fi‚⁄
Select Primary Language for the telephone display.
≤•fi‚¤
Select Alternate Language for the telephone display.
≤•fi‚‹
Select Alternate Language 2 for the telephone display.
≤•fi‚›
Select Alternate Language 3 for the telephone display.
Ring type
Select a different ring for your telephone.
1. Press ≤•fl.
2. Press ⁄, ¤, ‹, › or NEXT to hear the different
ring types.
3. Press OK to store the ring type.
Press here to remove the stand.
key hole slots
Use the key hole slots on the stand
to mark the location for the screws.
Tighten screws for a secure fit.
Mount the stand as shown.
refer to "Cord connections"
illustrations.