Mounting Of Handle - Dolmar MS-20U Instruction Manual

MOUNTING OF HANDLE

CAUTION: Before doing any work on the Brush cutter or Grass trimmer, always
switch off the motor and pull the spark plug connector off the spark
plug.
Always wear protective gloves!
CAUTION: Start the Brush cutter or Grass trimmer only after having assembled
it completely.
For machines with U Handle models
– Place the handle-fixing metal so that the handle with the control lever will be
positioned on the right (the right-hand grip side) as viewed from the engine
side, and the other handle on the left side.
– Fit the groove of the handle-fixing material to the handle end. Fix provisionally
the attached metal by hexagon socket bolt supplied.
– Adjust the handle to an easy-to-operate position, and tighten securely the
four hexagon socket bolts uniformly on the right and left by Allen wrench.
– Fasten the cable onto shaft which clip wire as shown in the diagram for
comfortable operation.
For machines with Loop Handle (CEN)
– Fix a barrier to the left side of the machine together with the handle for
operator's protection.
– Do not adjust position of the loop handle too close to the control grip. Keep
not less than 25 cm distance between the handle and the grip.
(a distance collar is provided for this purpose.)
to engine
10
MS-20U
Clip wire
MS-20U
MS-20C