How To Omit Zones - Honeywell ADE ACCENTA Gen4 User Manual

How to Omit Zones
User Guide
LED Keypad:
Enter your code [0][1][2][3].
The alann stops, and the Zone,
-?
or
sos
LEDs come on to show the
[0][1][2][3]
cause of the alann.
NOTE: When
2
or more LEDs are on, the flashing indicator shows the first
alann, and the steady indicators show the second and subsequent
alanns.
@ill
I
Press® .
®
If the Zone,
-?
or ® LEDs go out and the
00
LED comes
on, the system has been reset.
If any of the LEDs continue to flash then the system has been
programmed to be reset by the installer. In this case you must call the
installer to reset the system.
If
all LEDs light steady (not flashing), and the keypad stops working,
then the system has entered a fault-lockout. You must-call the installer
to rectifY this fault.
How to Omit Zones
If you cannot set the alann system because a detector is faulty and in constant alann you may need to
omit its zone from the alarm system. A zone which has been omitted cannot cause an alann. Omitted
zones will be restored after the system is unset.
Before a zone can be omitted it has to be enabled by the installer as a Used Zone and as an Omit
AUowzone.
LCD Keypad:
[4-digit code]
Enter your [ 4-digit code] to start the exit procedure (for
I
more infonnation see How to Set the System).
Program 1 Set
Press 8 and the exit beep tone stops, and the first
used zone that can be omitted appears on the display.
Press the zone [ number] or @ to be omitted.
The display now shows the zone as omitted. If a long
reject tone is heard, then the zone cannot be omitted.
cb
Press GO or allow the system to continue to set.
I
Program 1 Set
NOTE: Zn Zone number
**
SYSTEM SET
**
7
12345678
@@@@@@@@ C! @
_ _ , _ _ _ @sos:
@.-"
[Descriptor]
Omitted