Ce Declaration Of Conformity; According To The Ec Machinery Directive 2006/42/Ec Annex Ii 1A; Regulatory Notices For Transmitter; Fcc Notice (Usa) - Stanley QPM CORDLESS TOOL Instruction Manual

CE Declaration of Conformity

1.3 CE Declaration of Conformity

1.3.1 According to the EC Machinery Directive 2006/42/EC Annex II 1A

STANLEY Engineered Fastening Assembly Technologies declares that the QPM Cordless Tool conforms to all the
applicable regulations of the Machinery Directive. See the CE Declaration of Conformity that is delivered with
each QPM Cordless Tool.
The safety instructions on the supplied product information are to be followed.
1.4

Regulatory Notices for Transmitter

It is mandatory that national, state and local codes and standards be followed.

1.4.1 FCC Notice (USA)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The FCC requires the OEM to be notified of any changes or modifications. Changes or modifications not expressly
approved by STANLEY Assembly Technologies could void the user's authority to operate the equipment.
This device, using the integrated antenna, has been tested to comply with FCC CFR Part 15. The device meets the
requirements for modular transmitter approval as detailed in the FCC public notice DA00.1407.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• reorient or relocate the receiving antenna,
• increase the separation between the equipment and receiver,
• connect the equipment into an outlet on a circuit different from that to which the receiver is connected, or
• consult the dealer or an experienced radio/TV technician for help.
This device contains transmitter module FCC ID: QPU8200.
• To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 20 cm
(7.87 in) or more should be maintained between the antenna of this device and persons during operation.
To ensure compliance, operations at closer distances than this are not recommended.

1.4.2 Industry Canada Notice (Canada)

The term "IC" before the certification/registration number only signifies that the Industry Canada technical
specifications were met.
Le terme "IC" devant le numéro de certification /d'enregistrement signifie seulement que les
spécifications techniques Industrie Canada ont été respectées.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son
4
CAUTION
Cordless Tool