Advertisement
AireCare
Electronic
Air Filter
Grille
Protective
Edging
Strips
Upper
Bracket
Lower
Bracket
Figure 1. M1 Bracket
Installation
E2 AireCare
TM
Electronic
Air Filter
installation
Instructions
(2-4 Ton A/C)
Before starting this installation,
make sure that
all electrical
power to the furnace
has been
disconnected.
The E2 electronic
air filter kit consists of one
filter bracket, two screws, and the electronic air
filter with power cable.
Install the Brackets
1.
Remove
the grille from the top of the
furnace.
2.
As shown in Figure 2, place the filter bracket
into the grille frame and attach using the
two screws provided.
Install the Electronic
Air Filter
1.
Connect the electronic air filter power wires
(24 VAC) to the red and gray (or black) low
voltage
terminals
(R and C) in the E2
furnace.
Connect the power wire marked
with a white stripe or dash to C, the other to
R.
2.
Place the filter into the filter bracket and con-
nect the filter power cable by plugging it into
the connector located at the top of the filter.
3.
Turn
on power
to the furnace.
The
AireCare
TM
Electronic
Air Filter is active
if the light on top of the electronic
air filter
is lit.
4.
Replace the grille.
Advertisement
