NordicTrack NTTL25905 User Manual page 7

4. Slide the Grounding Bracket (71) onto one of the Handrail
Spacers (92) in the location shown.
See inset drawing A. Pinch the tabs on the Grounding
Bracket (71) so that the tabs will fit into the hole in the left
Upright (83 [see inset drawing B]).
See inset drawing B. Place the Handrail Spacer (92) on
the left Upright (83) as shown, with the cutout on the indi-
cated side. Note: Make sure that the tabs on the
Grounding Bracket (71 [see inset drawing A]) are inserted
into the hole in the left Upright.
5. Place the other Handrail Spacer (92) on the right Upright
(83) as shown, with the cutout on the indicated side (see
inset drawing A). Pull the Upright Wire Harness (131) up
through the cutout.
Have a second person hold the Handrails (73) near the
Uprights (83) as shown. Connect the Upright Wire
Harness (131) to the wires extending from the right
Handrail. Insert the connectors and the Upright Wire
Harness (131) into the opening in the Console Base (79
[see inset drawing B]).
Set the Handrails (73) on the Handrail Spacers (92),
being careful not to pinch the Wire Harness (131).
6. Insert two Handrail Bolts (96) with Handrail Washers
(95) and Handrail Bushings (94) into the right Upright
(83) and the right Handrail Spacer (92). Turn the
Handrail Bushings (94) so that they fit against the
Upright as shown in the inset drawing. Lift up the right
Handrail (73) and align the Bolts with the holes in the
Handrail. Next, thread the Bolts into the Handrail. Do
not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (96).
7. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the
floor or carpet from damage, place a mat under the treadmill.
4
71
B
92
5
79
92
6
7
A
92
Tabs
71
Cutout
83
A
Cutout
92
73
B 131
131
83
79
73
92
83
94
95
94
95
96