Table of Contents
Advertisement
Note 1:
• In some cases, the center panel may require some modification (trimming, filling, etc.).
Note 2:
• If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or
a similar tool.
Note 3:
• If reattaching screws which have been detached, remove any filings from the screws and
screw mounting bracket.
Removal
1. Remove the Detachable Control Panel (DCP). For instructions on removing the DCP,
refer to the owner's guide.
2. Press the outer escutcheon upward and remove it. (Figure 7)
3. Insert and lock the hook plates. (Figure 8)
4. Pull the hook plates to remove the main unit.
Outer Escutcheon
Figure 7
Cautions on Wiring
1. Be sure to turn the power off when wiring.
2. Be particularly careful where you route the cables. Keep them well away from the
engine, exhaust pipe, etc. Heat may damage the wires.
3. If the fuse should blow, check that the wiring is correct. If it is, replace the fuse with a
new one with the same amperage rating as the original one. (Figure 9)
4. When the main power supply fuse in the car is 15 A or less, purchase an automotive
cable that can withstand 15 A and supply this unit with power directly from the battery
to ensure that the unit will operate normally. Note that a fuse must be installed at a
distance no longer than 30 cm from the cable battery terminal to prevent accidents.
Fuse holder
Figure 9
28
CZ215A/CZ315A
Removal key
Figure 8
Fuse
Advertisement
Table of Contents
