Advanced; Virtual Server - D-Link DIR-808L User Manual

Section 3 - Configuration
The Virtual Server will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name: Enter a Name for the rule or select an application from
the drop-down menu. Select an Application Name
and click << to populate the field.
IP Address: Enter the IP Address of the computer on your
local network that you want to allow the incoming
service to. If your computer is receiving an IP address
automatically from the router (DHCP), you computer
will be listed in the "Computer Name" drop-down
menu. Select your computer and click <<.
Private Port/ Enter the port(s) that you want to open in the fields
Public Port: below Private Port and Public Port. The private and
public ports are usually the same. The public port is
the port seen from the Internet side, and the private
port is the port being used by the application on the
computer within your local network.
Protocol: Select TCP, UDP, or Both from the drop-down menu.
Schedule: The schedule of time when the Virtual Server Rule will
be enabled. The schedule may be set to Always, which
allows the service to always be enabled. You can create
your own times in the Tools > Schedules section.
Select Allow All (most common) or a created Inbound
Inbound Filter:
filter. You may create your own inbound filters in the
Advanced > Inbound Filter page.
D-Link DIR-808L User Manual

Advanced

Virtual Server

69