Child Restraints - Winnebago Chalet 22BR Owner's Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
one person use the same safety belt at any one
time, and do not let the safety belts become
damaged by pinching them in the doors or in the
seat mechanism. After any serious accident, any
seat belts which were in use at the time must be
inspected and replaced if necessary.
1- Insert tab into buckle
slot until it "clicks" and is
locked
2- Pull strap to tighten
Adjustment:
To lengthen belt, swivel the tab end at a right
angle to belt and pull strap to desired length. To
shorten, pull loose end of belt.
To Fasten:
Be sure belt is not twisted. Grasp each part of
the belt assembly and push tongue into buckle.
Adjust to a snug fit by pulling the loose end away
from the tongue.
To Release:
Press button in center of buckle and slide
tongue out of buckle.
WARNING
Snug and low belt positions are essential.
This will ensure that the force exerted by
the lap belt in a collision is spread over the
strong hip area and not across the
abdomen, which could result in serious
injury.
Only seats equipped with seat belts are to
be occupied while vehicle is in motion.
Swivel seats must be in the locked,
forward facing position while vehicle is in
motion.
3-2
Lap/Shoulder Belts
proper fastening, adjustment, and releasing of
lap/shoulder belts.
Seat Belt Care and Cleaning
•
•
3- Press to
release
•
•

CHILD RESTRAINTS

-If Equipped
restraint system can help reduce the chance or
severity of personal injury to a child in an
accident or during a sudden maneuver. Children
may have a greater chance of being injured in an
accident if they are seated in a child restraint
system which is not properly secured.
secured in a vehicle seat by a lap belt or the lap
belt portion of a lap-shoulder belt.
follow these guidelines:
1. Look for the label certifying that it meets all
2. Make sure that it will attach to your vehicle
See your chassis manual for instructions on
Be careful not to damage the belt webbing and
hardware. Take care not to pinch them in the
seat or doors.
Inspect the belts and hardware periodically.
Check for cuts, frays, and loose parts.
Damaged parts should be replaced. Do not
remove or modify the belt system.
Keep belts clean and dry. If the belts need
cleaning, use only a mild soap and water
solution. Do not use hot water. Do not use
abrasive cleaners, bleach, or dyes. These
products may weaken the belts.
Replace any belt assembly that was used
during a severe impact. Replace the complete
assembly even if damage is not apparent.
A properly installed and secured child
A child restraint system is designed to be
When purchasing a child restraint system,
applicable safety standards.
and restrain your child securely and
conveniently so that you are able to install it
correctly each time it is used.