Assembly - NordicTrack 831.298821 User Manual

Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Assembly
requires the included allen wrench
wrench .
1. With the help of a second person, carefully raise the
Uprights (70) until the Wheels (30) are resting flat on the
floor.
2. Remove the four Screws (43) from the posts on the left
and right Uprights (70). Slide the upper end of a Handrail
(101) onto the right Upright (70) as shown. Note: It will be
necessary to pivot the Handrail to the side and back
repeatedly (see arrow A) while pushing on the
Handrail (see arrow B) to slide it fully onto the Upright.
Next, pivot the lower end of the Handrail down, push it
toward the right Upright, and then align it with the indi-
cated hole.
Tighten two Screws (43) into the upper end of the Handrail
(101) and the right Upright (70).
Attach the other Handrail (101) to the left Upright (70) as
described above.
3. With the help of a second person, carefully tip the Uprights
(70) down as shown.
Tighten a Handrail Bolt (95) with a Handrail Washer (102)
into the right Upright (70) and the lower end of the right
Handrail (101) as shown. Note: It may be necessary to
press down on the Handrail to align the holes in the
upright and Handrail.
Next, tighten a Handrail Bolt (95) with a Handrail Washer
(102) into the left Upright (70) and the lower end of the left
Handrail (101) (not shown).
With the help of a second person, carefully tip the Uprights
(70) back to the upright position.
and your own phillips screwdriver
1
2
43
101
3
6
70
B
101
70
102
101
95
and adjustable
30
43
70
A
Hole
95
102
70