Fan Locations - HP HPE ProLiant ML30 Gen9 User Manual

Item LED
IMPORTANT: The Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode.
It cannot be enabled in Legacy BIOS Boot Mode. If the B140i controller is disabled, drives
connected to the system board Mini-SAS connectors operate in AHCI or Legacy mode. Under
this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities
Utilities" on page 82) to enable or disable the B140i controller (System Configuration →
BIOS/Platform Configuration (RBSU) → System Options → SATA Controller Options →
Embedded SATA Configuration).

Fan locations

Fan number
1
2
Status Definition
Solid amber The drive has failed.
Off The drive is not configured by a RAID controller.
Fan type
System fan
Front PCI fan (optional)
("HPE UEFI System
Component identification 15